DIY Embellished Wrap Bracelets
You’ll need:
3 yards of silk ribbon cord. I got mine (purple, of course) at JoAnn’s in the trim section.
2 dozen 8mm gold beads. My beads came from Dee’s but you can find beads with a similar size opening at JoAnn’s, Hobby Lobby or Michaels. If you can’t find them there, these are very similar.
Cut the ribbon into 3 equal lengths. Standard bracelet size is 7 inches so you’ll want it about 29 inches long in order to wrap 4 times.
Start by braiding about 6 inches of ribbon and then secure the end with a rubber band. Anchor the end with something heavy to hold in it place.
Start braiding in the beads by feeding the ball onto the middle strand and then tightly braiding the other two strands around it. Don’t pull too hard though or the beads will have a tendency to pop out as you go.
Continue feeding beads onto the middle strand until you run out (I had about 25) or until there’s about 6 inches of ribbon left
Finish with another 6 inches or so of braiding. Then clamp the ends with ribbon fasteners or just tie it in a knot.
It looks great as a bracelet or a necklace.
